Pompa Centrifugal Pedrollo Stainless AL-RED (SUS 304)


Range Of Performance

Maximum flow rate 160 l/min (9.6 m3/h)
Maximum head 23 m

Limits Of Use

Manometric suction lift up to 7 m
liquid temperature up to +90°C
Environment temperature up to +55°C

Installation and Use

It is recommended for pumping clean water and liquids that are chemically non aggresive to the materials from which the puump is made.
The construction of these centrifugal pumps makes them suitable for use in the domestic.

Agricutural and Industrial Sector

All the watted parts are in stainless steel AISI 340 to guarantee total hygiene and maximum resistance to corrosion.
The pump must be installed in enclosed places, or at least protected against inclement weather.

Construction Characteristics

  • Pump body : stainless steel AISI 304, with threaded ports ISO 228/1
  • Body Back-Plate and Diffuser : AISI 304
  • Impeller : stainless steel AISI 304, of the type with centrifugal radial flow
  • Motor Shaft : stainless steel EN 10088-3 – 1.4104
  • Mechanical Seal : ceramic – graphite – NBR
  • Electric Motor : the pumps are close-coupled to a carefully matched PEDROLLO electric motor, quiet running, totally enclosed fan cooled (TEFC), suitable for continuous duty
  • AL-RED 135m : single-phase 230V – 50 Hz with capacitor and thermal overload protector
  • Insulation : class F
  • Protection : IP 44
  • Registered mode n° 72753
  • AL-RED is a registered trade mark

Have any Question or Comment?

Leave a Reply

Your email address will not be published. Required fields are marked *

Copy Protected by Chetan's WP-Copyprotect.