General Data
Definition of Model
Niso 100-65-200/30
Niso : En suction diameter (mm)
65 : Drainage diameter (mm)
200 : Nominal diameter (mm) of impeller
30 : Motor power (kW)
Min Inlet Pressure
Min inlet pressure depent on NPSH + 0.5 m safety margin + gasified pressure. It should be re-calculated the inlet pressure if one the following happenns.
- The liquid is more warm
- The flow exceeds the nominate value
- Suction distance is very long or inlet pipe is very long
- System pressure is to little
- Inlet pressure is low
Typical Application
- Clean, thin, non-corrosive-flammable, or non-explosive liquid without grain of fiber
- Water supply system
- Heat, air condition system
- Booster, constant pressure water supply
- Firefigting, splitting system
- Irrigation, farming
- Industry cooling, heater circulation system
- Industry transferring, drainage system
Construction
- Non-self-priming single stage, single suction, horizontal. axial suction and radical discharge, pu, p body is fixed by base
- Use bearing cradle, which can orientate bearing, prevent from radical vibration, improve the regidity of rotary part
- Compacted shaft, use deep grove grease lubricated roller bearing
- Connect pump and motor with semi-flexible coupling
- Use standard wearable mechanical seal
- TEFC motor, size complies to IEC standard, installation type B3
- The dimension is comform to ISO 2858
Specification
| Flow | Max 520 m3/h |
| Head | Max 160 m |
| Working pressure | Max 16 bar |
| Inlet pressure | Max 6 bar |
| Power | Max 160 kW |
| Liquid temperature | -15°C – 110°C |
| Inlet and Outlet diameter | Inlet diameter DN50-DN200 |
| Outlet diameter DN32-DN 150 |
Cuve Conditions
- Curve tolerance is according to ISO9906, Annex A
- All curves based on the measured value of constant motor speed 2900 rpm. 2950 rpm, 145 rpm or 1480 rpm
- The measurement is were made with airless water at temperature of 120°C, The curves apply to a kinematic viscosity of 1 mm2/s (i cst)
Features
- Back-pull-out design, without having to disturb pump body and pipelines when servicing
- All the models only use 4 kid of pump shaft and bearing cover, make parts exchangeable
- Impeller is optimum design, inlet is enlarged, no whirlpool, deduct the water pump NPSH efficiency, which make pump work stable with little noise
- Casing and casing cover use wearing neck ring structure, which makes pump easy to mountain, make parts works longer. The replaceable seal ring, makes pump work efficiently in a long time.
